 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
FINAL DRIVE BEARINGS ADJUSTMENT - CONTINUED
0104 00
ADJUSTMENT - CONTINUED
7.
Remove torque wrench (19) and install ratchet wrench (20). Turn adjusting nut (11) to the right (six to ten lugs) and
lower torque to less than 350 lb-ft (475 Nm).
NOTE
If it is not possible to get a torque below 350 lb-ft (475 Nm) after adjusting nut is loosened, a track separa-
tion must be made (WP 0119 00) to make adjustment of bearings.
8.
Remove torque multiplier (18) and install torque wrench (19) and adapter. Tighten adjusting nut (11) to 350 lb-ft (475
Nm).
16
11 (HIDDEN)
18
18
19
20
386-567
386-568
9.
Move driver group (16) out of the way and put a mark
(21) on adjusting nut (11) and holder assembly (22) in
22
alignment with each other. Mark (23) on holder
11
assembly (22) should be placed to the left from mark
(21) and 5.84 in. +/- 0.06 in. (148.3 mm +/- 1.5 mm)
(distance "Z") from mark (21).
21
10.
Install driver group (16) on shaft of trunnion group.
11.
Install torque multiplier (18) and tighten adjusting nut
(11) until marks (21 and 23) are in alignment.
23
386-569
0104 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals