 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
0100 00
INSTALLATION - CONTINUED
6.
Install new retainer (23) in idler pinion (20). Install
21
20
gear (21) over idler pinion so that deep chamfer puts
retainer under compression. Retainer must be engaged
in groove of gear.
WARNING
Wear hand protection when handling hot com-
ponents to prevent burns.
23,24
7.
Heat two bearing races (22 and 24) to a maximum
temperature of 275F (135C) and install them on
each end of idler pinion (20).
22
386-541
NOTE
Apply gear lubricating oil in all race and roller assemblies to hold rollers in position for instal-
lation of inner races.
Weight of gear and idler pinion assembly is 120 lb (55 kg).
8.
Attach a nylon sling and a suitable lifting device to gear (21) and idler pinion (20) assembly and install assembly in
roller assembly (29) in cage assembly (27).
NOTE
Wire will hold gear and idler pinion in position until final drive case is installed.
9.
Fasten wire (A) around guide pins (4) to hold gear
4
(21) and idler pinion (20) in place.
A
21
3
4
20
386-533
0100 00-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals