 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TORQUE DIVIDER SCAVENGE PUMP REPLACEMENT - CONTINUED
0097 00
REMOVAL - CONTINUED
6.
Remove scavenge pump (5) from flywheel housing.
5
Remove and discard gasket (8).
7.
Remove forcing screws from scavenge pump (5).
8
386-396
INSTALLATION
WARNING
Exposure to silicone RTV compound may be hazardous to your health. Contact with eyes can cause severe
irritation and burns. Compound can be absorbed into the skin nd can cause irritation or skin sensitization.
Inhalation of vapors can cause respiratory tract irritation; prolonged inhalation can result in an allergic
reaction. Vapors are combustible. Do not use near open flame. Wear eye and skin protection and avoid
inhalation of vapors. Use only in a well-ventilated area. Failure to follow this warning can cause injury or
death.
CAUTION
Wipe area clean around mating surfaces of flywheel housing and scavenge pump before installation. Con-
tamination of transmission could result in premature failure.
1.
Apply silicone RTV compound to both sides of new gasket (8). Position new gasket on flywheel housing.
2.
Position scavenge pump (5) on flywheel housing. Ensure gear on scavenge pump is in alignment with drive gear in
torque divider.
3.
Install six new lockwashers (7) and capscrews (6).
4.
Install oil line (4) on scavenge pump (5) with split-type flange (3), four washers (2) and capscrews (1).
5.
Check transmission oil level and add as needed (WP 0086 00).
6.
Run engine and check scavenge pump for leaks (TM 5-2410-233-10).
7.
Close transmission guard (WP 0129 00).
END OF WORK PACKAGE
0097 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals