 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRANSMISSION ASSEMBLY REPLACEMENT - CONTINUED
0093 00
REMOVAL - CONTINUED
1.
Disconnect vent tube (1) from torque divider case.
2.
Disconnect two rods from steering brake at crossbeam (WP 0121 00).
3.
Remove two control rods from steering clutch control valve (WP 0123 00).
4.
Disconnect hose from hydraulic pressure control valve (WP 0094 00).
5.
Disconnect oil lines from transmission and manifold (WP 0088 00).
6.
For machines equipped with winch, disconnect hose from gear pump (WP 0147 00).
7.
Install four lifting links (2) with 3/4 -10 x 1-1/2 in. bolts to bosses on transmission assembly (3).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Transmission assembly weighs 1,150 lb (522 kg).
8.
Attach a suitable lifting device to lifting links (2) on transmission assembly (3) and take up slack.
9.
Disconnect hose from steering clutch relief valve (WP 0127 00).
10.
Remove ten nuts (4) and lockwashers (5) from transmission assembly (3) and bevel gear case studs. Discard
CAUTION
Transmission assembly must be lifted so that locator studs are level. This prevents binding and damage to
bottom locator studs.
11.
Remove transmission assembly (3) from machine. Place assembly on transmission stand or suitable cribbing.
12.
Remove gasket (6) from bevel gear case studs. Discard gasket.
INSTALLATION
1.
Install four lifting links (2) with 3/4 -10 x 1-1/2 in. bolts to bosses on transmission assembly (3).
WARNING
Exposure to silicone RTV compound may be hazardous to your health. Contact with eyes can cause severe
irritation and burns. Compound can be absorbed into the skin and can cause irritation or skin sensitiza-
tion. Inhalation of vapors can cause respiratory tract irritation; prolonged inhalation can result in an aller-
gic reaction. Vapors are combustible. Do not use near open flame. Wear eye and skin protection and avoid
inhalation of vapors. Use only in a well-ventilated area. Failure to follow this warning can cause injury or
death.
0093 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals