 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRANSMISSION ASSEMBLY REPLACEMENT - CONTINUED
0093 00
INSTALLATION - CONTINUED
NOTE
Ensure mounting surfaces are clean and dry before installation.
2.
Apply silicone RTV compound to both sides of new gasket (6). Place new gasket on bevel gear case studs.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
CAUTION
Transmission assembly must be lifted so that locator studs are level. This prevents binding and damage to
bottom locator studs.
NOTE
Transmission assembly weighs 1,150 lb (522 kg).
1.
Attach a suitable lifting device to lifting links (2). Install transmission assembly (3) in machine.
2.
Install six new lockwashers (5) and nuts (4) to secure
4,5
transmission assembly (3) to bevel gear case.
3.
Connect hose to steering clutch relief valve (WP 0127
6 (HIDDEN)
4.
Remove lifting device, four bolts and lifting links (2).
5.
For tractors equipped with winch, connect hose to gear
pump (WP 0147 00).
6.
Connect oil lines to transmission and manifold (WP
7.
Connect hose to hydraulic pressure control valve (WP
8.
Connect two control rods to steering clutch control
valve (WP 0123 00).
3
9.
Connect vent tube (1) to torque divider case.
1
386-386
2
0093 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals