 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
GOVERNOR AND FUEL INJECTION PUMP HOUSING REPLACEMENT - CONTINUED
0051 00
INSTALLATION - CONTINUED
CAUTION
Wipe area clean around mating surface of engine and governor and fuel injection pump housing prior to
installation. Contamination of fuel system could result in premature failure.
NOTE
Apply a light film of clean oil to new O-rings before installation.
2.
Install two new O-rings (12 and 13) on governor and fuel injection pump housing (9).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Governor and fuel injection pump housing weighs 56 lb (25 kg).
3.
Wrap a nylon sling around governor and fuel injection pump housing (9) and attach sling to suitable lifting device.
4.
Position governor and fuel injection pump housing (9) on engine and secure with three nuts (11).
5.
Secure governor and fuel injection pump housing (9) to oil manifold with two bolts (10).
6.
Install pump drive gear (8) on taper of fuel pump camshaft (7).
7.
Install washer (6) on fuel pump camshaft (7).
13
8
12
1,2
7 (HIDDEN)
9
3
4
11
10
5
6
386-272
386-271
0051 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals