Figure 4-36. Parking brake lever and cable, exploded view.

(2) R e m o v a l .

(a) Remove rear floor plate from tractor

chassis.

(b) Release parking brake lever and remove

two nuts (2, fig. 4-36) and screws (11). Remove

parking brake (1) from body panel.

(c) Back off adjusting nuts (9) on parking

brake cable (10),

(d) Remove parking brake cable clamping

screw (5), nut (3) and washer (4).

(e) Remove adjusting screw cover plate (15,

fig. 4-37) and disengage ball end of parking brake

cable from operating lever (18).

,boot

(f) Remove inner washer (6, fig.

(7) and outer washer (8) from parking brake cable

(10) and remove parking brake with attached cable

from tractor.

(3) Cleaning and inspection.

(a) C l e a n a l l p a r t s w i t h S D a n d d r y

thoroughly.

(b) Inspect all parts for wear, breaks and

other damage. Check parking brake lever for free

operation and stripped threads on cap. Inspect

cable for kinks, freedom of movement and security

of ball attachment at end of cable.

(c) Replace all unserviceable parts.

(4) I n s t a l l a t i o n . Reverse procedure in (2)

above. Cable length adjusting nut (9) should be

positioned against cable housing so that clearance

of 0.005 to 0.0010 inch exists between parking

brake cable (10) and lever (18, fig. 4-37). Adjust

parking brake as described in (1) above.

Figure 4-36. Parking brake lever and cable, exploded view.