(2) Install upper half of two clamp assemblies to support bracket and secure with two MS90725-61
screws, MS27183-14 washers, and MS51943-5 nuts as shown in figure 11.
(3) Install two MS21333-127 clamps on two bolts and install bolts through upper and lower clamp
halves and secure with two nuts as shown in figure 11. Tighten nuts finger tight.
Ensure the 5.25-inch measurement is made as shown in figure 10 prior to
performing step 4.
(4) Secure four screws and nuts installed in steps 2 and 3.