Section III. AIR INDUCTION AND EXHAUST SYSTEM

Figure 5-23 Fuel tank, removal and installation.

c. Cleaning.

CAUTION

(1) Drain the fuel tank (TM 5-2410-233-20).

Fill tank with water prior to welding

tank.

(2) Flush the tank with cleaning solvent (Fed.

Spec. P-D-680) and rinse with clean diesel fuel.

(3) Remove corrosion with sandpaper or by

sand b l a s t i n g and paint tank according to

d. Inspection and Repair.

procedures in TM 9-213.

(1) Inspect the fuel tank for corrosion, cracks,

(4) Replace a defective cap, strainer, drain

punctures, dents, or other damage. Inspect cap,

valve, or a severely dented or otherwise defective

strainer, and drain valve for damage.

fuel tank.

(2) Weld cracks and punctures according to

d. Installation. Reverse removal procedure and

TM 9-237.

install the fuel tank on the tractor.

Section Ill. AIR INDUCTION AND EXHAUST SYSTEM

5-15. Air Cleaner

(2) Remove 5 bolts (fig. 5-24), loosen 2 hose

clamps, precleaned clamp, and remove precleaner,

a. Removal.

air cleaner body and elbows.

(1) Refer to TM 5-2410-233-20 and remove

air cleaner element.