GENERAL ASSEMBLY INSTRUCTIONS (CONT). -726250941

TM 9-2320-364-34-1

c. Torquing. Tighten bolts, screws, washers, hoses and fittings as required in Appendix D or in each

maintenance task.

d. Identification Tags. Put hoses, tubes, lines, and electrical wiring in place by matching identification tags and

markings on equipment.

e. Hoses, Airline and Wiring. After installing hoses, air lines and wiring, ensure that they do not contact moving

parts or components edges. Secure in place, out of way with cable ties and cushion clips.

Hose and Fitting Tightening Procedure.

NOTE

Tighten hoses and fittings as

required in Appendix D or in each

maintenance task. If a torque

wrench and crowsfoot are not

available or cannot be used, use

the following procedure.

(1)

Install hose nut (1) on fitting (2).

ALIGNMENT

MARKS

NOTE

When turning effort increases,

hose nut seat is in contact with

adapter seat.

(2)

Tighten hose nut (1) until seated on

fitting (2).

NOTE

Alignment marks allow the

mechanic to count the number of

flats the hose nut has rotated

during tightening.

(3)

Scribe alignment mark on hose nut (1) and

fitting (2).

(4)

Tighten hose nut (1) until mark on hose nut

has rotated correct number of flats (Refer to

2-857