 |
|||
|
|
|||
|
Page Title:
SELF-RECOVERY WINCH (SRW) DOES NOT OPERATE. (Cont) |
|
||
| ||||||||||
|
|
 TM 9-2320-364-34-1
1. SELF-RECOVERY WINCH (SRW) DOES NOT OPERATE (CONT).
High pressure hydraulics [oil under 3700 psi
S
(25,512 kPa) pressure] operate this
equipment. Refer to truck operator and
maintenance manuals for hydraulic oil
pressure. Never disconnect any hydraulic line
or fitting without first dropping pressure to
zero. Failure to comply may result in injury to
personnel.
Fuel and oil are slippery and can cause falls.
S
To avoid injury, wipe up spilled fuel or oil with
rags.
NOTE
Use drain pan to catch leaking hydraulic oil.
PRESSURE TEST (CONT).
(5) Start engine (TM 9-2320-364-10).
(6) Set WINCH/CRANE switch to
WINCH position.
(7) Set hydraulic selector switch to
CRANE/SRW position.
(8) Move freespooling lever to
disengage position.
(9) With the aid of an assistant, hold
winch lever in the forward position
while observing pressure gauge.
(10) With the aid of an assistant, hold
winch lever in the rearward position
while observing pressure gage.
(a) If 290 psi (2000 kPa) or more
are not measured with lever
forward and also with lever
rearward, go to Step 2 of this
Fault.
(b) If 290 psi (2000 kPa) or more
are measured with lever held in
forward position and also with
lever held in rearward position,
perform Steps (11) through (14)
below and go to Step 4 of this
Fault.
(11) Set hydraulic selector switch to OFF
position.
(12) Turn OFF ENGINE switch.
Continued on next page.
2-730
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals