 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-364-34-1
Remove all jewelry such as rings, dog
tags, bracelets, etc. If jewelry or tools
contact positive electrical circuits a direct
short may result. Damage to equipment,
injury or death to personnel may result.
Do not stand under crane. Mechanical
failure and operator error can cause injury
or death to personnel.
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesives, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap
and water.
Hooked test unit connector must not
contact other transistor wire or damage
to OSS and test unit will result.
CALIBRATION TEST (CONT).
(15) Set crane main POWER switch to
OFF position (TM 9-2320-364-10).
(16) Set hydraulic selector switch to OFF
position.
(17) Turn OFF engine switch.
(18) Disconnect four connectors from
OSS box.
(19) Install cover on central processor
unit with four screws.
(20) Install safety lock seal on two
screws.
(21) Install cover on OSS box with four
screws and preformed packings.
(22) Apply bead of sealant to edge of
cover where it is against OSS box.
2-715
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals