MAST DOES NOT LOWER. (Cont) -726250595

TM 9-2320-364-34-1

High pressure hydraulics [oil under 3000 psi (20,685 kPa) pressure] operate this equipment. Refer to

vehicle operator and maintenance manuals for hydraulic oil pressure. Never disconnect any hydraulic

line or fitting without first dropping pressure to zero. Failure to comply may result in injury to personnel.

Fuel and oil are slippery and can cause falls. To avoid injury, wipe up spilled fuel or oil with rags.

NOTE

Use a drain pan to catch leaking hydraulic oil.

FLOWMETER TEST

(1) Tag, mark and disconnect hose

from fitting at bottom of MAST

valve. Discard preformed packing.

(2) Connect adapter hose with

preformed packing to disconnected

hose.

(3) Connect adapter hose to flowmeter

IN port.

(4) Connect adapter hose with

preformed packing to fitting.

(5) Connect adapter hose to flowmeter

OUT port.

(6) Open flowmeter load valve.

(7) Start engine (TM 9-2320-364-10).

(8) Set WINCH/CRANE switch to

CRANE position.

(9) Set hydraulic selector switch to

CRANE/SRW position.

(10) Turn ON crane POWER

switch.

(11) Hold MAST control lever in DOWN

position while observing flowmeter.

(a) If more than 0 gpm (0 lpm)

are present, perform Steps (12)

through (17) below and replace

erection cylinder (Para 16-5).

(b) If 0 gpm (0 lpm) are present,

cylinder piston seals are OK.

Fault not corrected. Perform

Steps (12) through (17) below

and notify supervisor.

(12) Set crane POWER switch to

OFF position.

(13) Set hydraulic selector switch to OFF

position.

(14) Turn OFF ENGINE switch.

(15) Disconnect adapter hose from crane

hose. Discard preformed packing.

(16) Disconnect adapter hose from

fitting. Discard preformed packing.

(17) Connect crane hose with preformed

packing to fitting.

2-511