 |
|||
|
|
|||
|
Page Title:
OUTRIGGERS DO NOT OPERATE OR OPERATE SLOWLY. (Cont) |
|
||
| ||||||||||
|
|
 TM 9-2320-364-34-1
High pressure hydraulics [oil under 3000 psi
S
(20,685 kPa) pressure] operate this
equipment. Refer to vehicle operator and
maintenance manuals for hydraulic oil
pressure. Never disconnect any hydraulic line
or fitting without first dropping pressure to
zero. Failure to comply may result in injury to
personnel.
Fuel and oil are slippery and can cause falls.
S
To avoid injury, wipe up spilled fuel or oil
with rags.
NOTE
Use a drain pan to catch leaking hydraulic
oil.
FLOWMETER TEST
(1) Remove four screws, lockwashers,
nuts, eight washers and cover.
Discard lockwashers.
(2) Disconnect tube from four valve
bank center manifold elbow.
Discard preformed packing.
(3) Disconnect tube from bottom right
solenoid valve assembly adapter
(below crane hydraulic system
manual override). Discard
preformed packing.
(4) Install cap on elbow.
(5) Connect adapter hose with
preformed packing to solenoid
valve assembly adapter.
(6) Connect flowmeter IN port to
adapter hose connected to solenoid
valve assembly.
(7) Disconnect hose 2917 male quick
disconnect from LHS control box
female quick disconnect.
(8) Connect adapter hose to hose 2917
quick disconnect.
(9) Connect flowmeter OUT port to
adapter hose connected to quick
disconnect.
(10) Disconnect high speed fan
connector at multifunction valve.
(11) Open flowmeter load valve fully.
(12) Disconnect connector MC59 from
EPAC.
(13) Set hydraulic selector switch to
CRANE/SRW position.
(14) Start engine (TM 9-2320-364-10).
(15) Set crane POWER switch to
ON position.
Continued on next page.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals