Click here to make tpub.com your Home Page

Page Title: LOSS OF HOOK ARM LOAD HOLDING. (Cont)
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-364-34-1
High pressure hydraulics [oil under 3675 psi (25,339 kPa) pressure] operate this equipment. Refer to
vehicle operator and maintenance manuals for hydraulic oil pressure. Never disconnect any hydraulic
line or fitting without first dropping pressure to zero. Failure to comply may result in injury to personnel.
Fuel and oil are slippery and can cause falls. To avoid injury, wipe up spilled fuel or oil with rags.
All personnel must stand clear during lifting operations. A swinging or shifting load may cause injury or
death to personnel.
Do not get under LHS when disconnecting or
connecting connectors or hoses. A hydraulic
malfunction could cause LHS to lower causing
serious injury.
NOTE
Use drain pan to catch leaking hydraulic oil.
VISUAL INSPECTION
(1) Attach 500 lb (227 kg) minimum
load to hook.
(2) Raise hook arm approximately half
of its travel (TM 9-2320-364-10).
(3) Set hydraulic selector switch to OFF
position.
(4) Turn OFF ENGINE switch.
(5) Disconnect hose 2881 from LH hook
arm manifold, port VB. Plug hose.
(6) Disconnect hose 2892 from RH
hook arm manifold, port VB. Plug
hose.
(6) Allow one to two minutes to pass to
allow excess oil laying in manifold
to drain out.
(a)  If hydraulic fluid stops draining
from hook arm manifolds, load
control valves are OK. Perform
Steps (7) through (13) below and
go to Step 3 of this Fault.
(b)  If hydraulic fluid continues to
drain from LH or RH hook arm
manifold at port VB, remove plug
from hose and connect hose to
hook arm manifold that does not
leak. Replace load control valve
at leaking port VB (Para 17-13).
(7) Remove plugs from hoses 2881
and 2892.
(8) Connect hose 2881 to LH hook arm
manifold, port VB and hose 2892 to
RH hook arm manifold, port VB.
(9) Turn ON ENGINE switch.
(10) Set hydraulic selector switch to
MAN HA position.
(11) Disengage LHS hook arm from load.
(12) Set hydraulic selector switch to OFF
position.
(13) Turn OFF ENGINE switch.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business