|
|
TM 9-2320-364-34-1
All personnel must stand clear during lifting operations. A swinging or shifting load may cause injury or
death to personnel.
NOTE
Only remove center screw on engine side of
LHS control box cover.
OPERATION TEST
(1) Remove four screws, lockwashers and
LHS control box cover. Discard
(2) Position LHS hook to rear of truck
(TM 9-2320-364-10).
(3) Attach 500 lb (227 kg) minimum load
to hook.
(4) Raise hook arm approximately half of
its travel.
(5) Push in hook arm safe lowering
button.
(a) If hook arm does not safe lower,
lower load using normal controls,
Perform Steps (6) through (9)
below and go to Step 5 of
this Fault.
(b) If hook arm does safe lower,
perform Steps (6) through (9)
below and go to Step 2 of this
Fault.
(6) Remove load from hook.
(7) Put LHS in transit position.
(8) Set hydraulic selector switch to
OFF position.
(9) Turn OFF ENGINE switch.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |