SOLENOIDS J, F, D, C, B, A, G, E OR H CIRCUIT FAULTY.

TM 9-2320-364-34-1

2-11. TRANSMISSION SYSTEM TROUBLESHOOTING (CONT).

5. SOLENOIDS J, F, D, C, B, A, G, E OR H CIRCUIT FAULTY.

INITIAL SETUP

Tools and Special Tools

References

Tool Kit, General Mechanic's

TM 9-2320-364-10

(Item 240, Appendix F)

TM 9-2320-364-20

Analyzer Set, STE/ICE-R (Optional)

TM 9-4910-571-12&P

(Item 15, Appendix F)

Equipment Condition

Cartridge, ATEC (Item 28, Appendix F)

Engine OFF, (TM 9-2320-364-10)

Harness, Breakout (Item 94, Appendix F)

Parking brake applied, (TM 9-2320-364-10)

Multimeter (Item 140, Appendix F)

Wheels chocked, (TM 9-2320-364-10)

Reader, Diagnostic (Item 180, Appendix F)

Left rear fender skirt removed,

Jumperwire

(TM 9-2320-364-20)

Transmission internal oil filter removed, (Para 7-4)

START

KNOWN INFO

TEST OPTIONS

WARNING

Read WARNING

Unit Troubleshooting tasks

Resistance test.

on Page 2-141

completed.

STE/ICE-R #91.

Solenoid codes displayed on

DDR.

REASON FOR QUESTION

Are 9 to 20 ohms measured

Truck wiring OK.

across solenoid coil?

If there are less than 9 ohms,

solenoid is faulty.

POSSIBLE PROBLEMS

Solenoid faulty.

Solenoid wiring harness

assembly faulty.

ATEC ECU faulty.

Replace solenoid

(Para 7-7).

Verify repair, go to

Step 3 of this Fault.

YES

2-140