 |
|||
|
|
|||
|
Page Title:
WHITE EXHAUST SMOKE (ENGINE AT NORMAL OPERATING TEMPERATURE). (Cont) |
|
||
| ||||||||||
|
|
 TM 9-2320-364-34-1
Allow engine to cool before performing
troubleshooting maintenance. If necessary
use insulated pads and gloves. Hot engine
components will burn and cause injury to
personnel.
Do not remove the radiator cap when the
engine is hot; steam and hot coolant can
escape and burn personnel.
Use a clean, thick waste cloth or like material
to remove the cap. Avoid using gloves. If hot
water soaks through gloves, personnel could
be burned.
AFTERCOOLER INSPECTION
(1) Remove right side noise panel
(TM 9-2320-364-20).
(2) Remove eight screws, lockwashers,
washers and left side noise panel.
Discard lockwashers.
(3) Remove 14 screws, six engine air box
covers and gaskets. Discard gaskets.
(4) Remove radiator cap
(TM 9-2320-364-10).
(5) Install cooling system pressure tester
on radiator.
(6) Pressurize cooling system to 10 psi
(69 kPa) and check air box for
coolant.
(a) If coolant is found in air box,
replace aftercooler (Para 5-5).
(b) If no coolant is found in air box,
perform Step (7) below and go to
Step 5 of this Fault.
(7) Release pressure.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals