 |
|||
|
|
|||
|
Page Title:
ENGINE DOES NOT DEVELOP FULL POWER. (Cont) |
|
||
| ||||||||||
|
|
 TM 9-2320-364-34-1
Do not run more than two compression
unbalance tests in a row.
A fail message means compression is too
far unbalanced to measure with
STE/ICE-R.
STE/ICE-R #14
(1) Remove dust cover from DCA
connector MC39.
(2) Connect DCA cable W1 to the
vehicle test meter (VTM) and DCA
connector.
(3) Power up STE/ICE-R VTM in the
DCA mode, (TM 9-4910-571-12&P).
(4) Perform confidence Test.
(5) Enter vehicle identification
number (VIN) (38).
(6) Perform STE/ICE-R #72 test.
(7) Perform STE/ICE-R #73 test.
(8) Perform STE/ICE-R #74 test.
(9) Perform STE/ICE-R #75 test.
(10) Set test select switch to #14.
(11) Press and release test button.
(12) Wait for a GO to appear on VTM
display. If "UEH" appears, refer to
TM 9-4910-571-12&P, test #14, and
enter following information:
AT
ENTER
CYL
-
-
04
CV1
-
-
3
CV2
-
-
98
CV3
-
-
43
CV4
-
-
4
CV5
-
-
53
(13) Push down and hold engine stop
switch and crank engine until OFF
appears on VTM display. If a GO
appears, repeat Steps (10) through
(13) above.
(14) Stop cranking engine and release
engine stop switch, observe
number displayed on VTM display.
Number displayed is the percent
unbalance between the highest and
lowest cylinders. If "UEH"
appeared, valves for Step "A" will
be "1.00 min to 1.20 max". Valve
for Step "B" will be "above 1.20".
(a) If the percentage of unbalance
is between 0 and 11 percent,
perform Steps (15) and (16)
below and replace engine,
(Para 3-4).
(b) If the percentage of unbalance
cylinder is above 11 percent,
perform Steps (15) and (16)
below and go to Step 11 of this
Fault.
(15) Disconnect DCA cable W1 from
DCA connector MC39.
(16) Install dust cover on DCA connector
MC39.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals