ENGINE DOES NOT DEVELOP FULL POWER. (Cont) -726250129

TM 9-2320-364-34-1

Do not stand in front of vehicle when testing air box pressure. Brakes could fail and vehicle could move

forward causing injury or death.

Do not operate vehicle with transmission

engaged and engine at maximum RPM for

more than 15 seconds at a time.

Transmission oil heats up quickly and could

cause damage to transmission.

STE/ICE-R #30

(1) Remove dust cover from DCA

connector MC39.

(2) Connect DCA cable W1 to the

vehicle test meter (VTM) and DCA

connector MC39.

(3) Power up STE/ICE-R VTM in the

DCA mode, (TM 9-4910-571-12&P).

(4) Set test select switch to #30.

(5) Start engine and allow engine to

run for 5 minutes,

(TM 9-2320-364-10).

(6) Perform Offset test,

(TM 9-4910-571-12&P).

(7) Apply brake pedal and move

transmission range selector to

drive (D) position.

(8) Press and hold throttle pedal

to floor.

(9) Press and release test button to

obtain test results.

(a) If turbocharger outlet pressure is

not 9.3 psi (64 kPa), perform

Steps (10) through (14) below

and go to Step 3 of this Fault.

(b) If turbocharger outlet pressure is

9.3 psi (64 kPa), perform Steps

(10) through (14) below and go

to Step 5 of this Fault.

(10) Return engine rpm to approximately

600 rpm.

(11) Move transmission range selector to

neutral (N) position.

(12) Turn OFF ENGINE switch.

(13) Disconnect DCA cable W1.

(14) Install dust cover on DCA connector

MC39.