ENGINE DOES NOT DEVELOP FULL POWER. (Cont) -726250127

TM 9-2320-364-34-1

Allow engine to cool before performing troubleshooting maintenance. If necessary use insulated pads

and gloves. Hot engine components will burn and cause injury to personnel.

VISUAL INSPECTION

(1) Remove right side noise panel,

(TM 9-2320-364-20).

(2) Remove eight screws, lockwashers,

washers and left side noise

panel. Discard lockwashers.

(3) Start engine, (TM 9-2320-364-10).

(4) Check exhaust manifold, gasket and

clamps for leaks and damage.

(a) If clamps are loose, tighten

clamps. If exhaust manifold or

gaskets are leaking or damaged

replace exhaust manifold and/or

gaskets, (Para 3-31).

(b) If exhaust manifold or gaskets are

not leaking or damaged, perform

Step (5) below and go to Step 2

of this Fault.

(5) Turn OFF ENGINE switch.