Custom data list -726250103

TM 9-2320-364-34-1

NOTE

In the diagnostic mode, the ATEC ECU update rate is approximately 1 seconds. If the

transmission is shifting rapidly, it is possible that the transmission may pass through

several "attained" ranges more quickly than the readout can display them. This is not a

fault of either the ATEC ECU or the DDR.

In this mode, the update rate is about of a second, so the values received will be more accurate than

(b)

in the normal data list mode.

(c)

Range selected readout:

R - Reverse

N - Neutral

F5 - 1st through 5th (Drive)

F4 - 1st through 4th (Drive)

F3 - 1st through 3rd (Drive)

F2 - 1st through 2nd

F1 - 1st

(d)

Range attained readout:

R2 - Second reverse

R - Reverse

N - Neutral

1C - 1st converter

1L - 1st lockup

2C - 2nd converter

2L - 2nd lockup

3C - 3rd converter

3L - 3rd lockup

4C - 4th converter

4L - 4th lockup

5C - 5th converter

5L - 5th lockup

(9)

Custom data list. When you use your DDR to read data for an ATEC I system, it will be displayed in the

same order each time because the list is fixed in the DDR's memory.

(a)

There may be some instances when the programmed order of the data list is not convenient. For

example, in order to solve a particular driveability problem, you need to look at TPS, Range

SEL/ATT and Lockup RPM, all at the same time. But these three pieces of information are not

together in the data list. The following text describes a method to watch all three items at the same

time.

(b)

Locate Custom Data List in the DDR Main Function menu and press ENTER.

(c)

Once you enter the Custom Data List mode, you will be given a choice between continuing to use the

standard list or creating a custom list. The default is STANDARD.

2-21