 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-364-34-1
(7)
Clear ATEC codes.
(a)
Turn OFF ENGINE switch (TM 9-2320-364-10).
(b)
Place a jumper wire between terminals A and B on DDL connector MC13.
(c)
Start engine (TM 9-2320-364-10).
(d)
Observe "TRANS CHECK" light for codes being flashed.
(e)
Apply brake and shift the transmission in the following sequence:
1
N (Neutral).
2
D (Drive).
3
R (Reverse) (Leave in reverse until "TRANS CHECK" light stops flashing, approximately five
seconds).
4
N (Neutral).
(f)
If "TRANS CHECK" light stops flashing, codes have been cleared and fault corrected.
(g)
If "TRANS CHECK" light continues flashing, fault has not been corrected.
(h)
Turn OFF ENGINE switch.
(i)
Remove jumper wire.
(8)
Range selected/range attained. When the driver selects a specific range for the transmission, the ATEC
ECU begins shifting the transmission through the various ranges, depending on operating conditions, until
the selected range is attained. Under some conditions, the range selected and the range attained will be
the same. In other cases, the transmission will not attain the range selected. This information is of
diagnostic value.
(a)
When you select this function, the DDR reads out the range selected and the range attained.
RANGE
RANGE
SELECTED
ATTAINED
N
N
Data Readout Window
2-20
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals