 |
|||
|
|
|||
|
Page Title:
VEH5V - VEHICLE HARNESS +5 VOLTS SUPPLY (CONT'D) |
|
||
| ||||||||||
|
|
 TM 9-2320-364-20-1
Section IV. TROUBLESHOOTING CHARTS (Cont.)
E. VEH5V - VEHICLE HARNESS +5 VOLTS SUPPLY (CONT'D)
STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
VEH5V-7
Check Vernier Control
Sensor Connectors
Inspect terminals at the vernier
Terminals and
Replace vernier control (para
control connectors (sensor side
connectors are okay.
7-100). Then go to VEH5V-30.
and harness side) for damage;
bent, corroded and unseated pins
Problem found.
Repair terminals/connectors
or sockets.
(para 7-101).Then go to
VEH5V-30.
VEH5V-8
Check TPS
Turn ignition off.
Getting 64-205
Go to VEH5V-10.
Reconnect the Throttle Position
counts at no throttle and
Sensor (TPS) connector.
no more than 968
Turn ignition on.
counts at full throttle.
Select TPS CNTS for display
on the DDR.
Not getting the
Go to VEH5V-9.
Observe throttle counts at both no
above readings.
throttle and full throttle (engine
not running).
VEH5V-9
Check TPS
Connectors
Turn ignition off.
Terminals and
Replace TPS (para 7-58).
Disconnect the Throttle Position
connectors are okay.
Then go to VEH5V-30.
Sensor (TPS) connector.
Inspect terminals at the TPS
Problem found.
Repair terminals/connectors
connectors (sensor side and
(para 7-101). Then go to
harness side) for damage; bent,
VEH5V-30.
corroded and unseated pins or
sockets.
2-771
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals