Click here to make tpub.com your Home Page

Page Title: P187 4 - VERNIER CONTROL INPUT FAILED LOW (VOLTAGE LOW) (ALSO CALLED VARIABLE SPEED GOVERNOR - VSG) (cont)
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-364-20-1
Section IV. TROUBLESHOOTING CHARTS (Cont.)
E. FLASH CODE:
11
J1587 CODE:
P187 4 - VERNIER CONTROL INPUT FAILED LOW (VOLTAGE LOW)
(ALSO CALLED VARIABLE SPEED GOVERNOR - VSG)
STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
11-9
Check ECM
Connectors
Check terminals at the
Terminals and
Replace ECM (para 7-57).
vehicle harness connector (both
connectors are okay.
Then go to 11-30.
the ECM and harness side) for
damage; bent, corroded, and
Problem found.
Repair terminals/connectors
unseated pins or sockets.
(para 7-101). Then go to 11-30.
11-10
Check for Short
Turn ignition off.
Less than or
The vehicle +5 volt line
Disconnect the vehicle harness
equal to 10,000 ohms.
(ckt #916) is shorted to the
connector at the ECM.
return line (ckt #952). Repair
Read resistance between sockets
short. Then go to 11-30.
A and C on the vernier control
connector.
Greater than
Go to 11-11.
10,000 ohms or open.
11-11
Check for Open +5 Volt
Line
Install a jumper wire between
Less than
Go to 11-9.
sockets A and C of the vernier
or equal to 5 ohms.
control connector.
Read resistance between sockets
Greater than
The vehicle +5 volt line (ckt
A3 (916) & C3 (952) on the vehicle
5 ohms or open.
#916) is open. Repair open.
harness connector.
Then go to 11-30.
11-12
Check for Short to
Battery +
Turn ignition off.
All readings are
Go to 11-13.
Pull out both DDEC circuit
greater than 10,000
breaker buttons (CB22 & CB23).
ohms or open.
Disconnect 5-way power harness
connector at the ECM.
Any reading is
A short exists between sockets
Read resistance between sockets
less than or equal
where less the 10,000 ohms
D1 (510) & B3 (439) on the vehicle
to 10,000 ohms.
resistance was read. Repair
harness connector.
short and reset circuit breakers.
Also read resistance between
Then go to 11-30.
socket D1 (510) on the vehicle
harness connector and the
following sockets on the 5-way
power harness connector: C, D,
E, and B.
2-621

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business