|
|
TM 9-2320-364-20-1
STEERING WHEEL
SHOWN REMOVED
FOR CLARITY
DDL
CONNECTOR
MC13
ENGINE
SWITCH
NOTE
DDR should read OFF when engine is started
and while increasing or holding throttle.
When throttle is released, display changes
to ON. When engine returns to idle, DDR
will read OFF.
DDR TEST
(1) Connect DDR to DDL
connector MC13.
(2) Start ENGINE (TM 9-2320-364-10).
CHECK
(3) Select MODE 30 (ENG BRK ENBLE)
ENGINE
on DDR.
(4) Run engine at greater than 1800 rpm
for 10 seconds and quickly release
throttle control.
(a) If DDR does not read ON when
throttle is released and return to
DDR
OFF when engine speed returns
DIAGNOSTIC
POWER
to idle, turn OFF ENGINE switch
DATA READER
and go to Electrical
CABLE
(DDR)
Troubleshooting (Para 2-20)
Faults 34 and 35.
(b) If DDR reads ON when throttle is
released and OFF when engine
speed returns to idle, turn OFF
ENGINE switch and go to Step 2
of this Fault.
2-473
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |