 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-364-20-1
DDR TEST
(1) Clear codes on DDR (Para 2-11).
(2) Turn ON ENGINE switch
(TM 9-2320-364-10).
(3) Select MODE 01 (ACTIVE CODES)
on DDR.
(a) If Code 32 does not appear, turn
OFF ENGINE switch and go to
Step 3 of this Fault.
(b) If Code 32 does appear, turn OFF
ENGINE switch and replace
DDEC ECM (Para 7-56).
(4) Disconnect DDR from DDL
connector MC13.
(5) Turn OFF ENGINE switch.
VERIFY REPAIR
(1) Turn ON ENGINE switch
(TM 9-2320-364-10).
(2) Clear codes on DDR (Para 2-11).
(3) If CEL does not stay ON, start engine
and run for 8 minutes or until CEL
comes ON.
(a) If CHECK ENGINE light comes on
and stays on, perform Steps (4)
and (5) below and go to Fault
Index (Table 2-16).
(b) If CHECK ENGINE light comes on
for about five seconds and then
goes off, fault has been corrected.
(4) Turn OFF ENGINE switch.
(5) Disconnect DDR from DDL connector
MC13.
2-263
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals