FRONT BUMPER REPLACEMENT -699580886

TM 9-2320-363-20-2

FRONT BUMPER REPLACEMENT

This task covers:

a. Removal

b. Cleaning/Inspection

c. Installation

INITIAL SETUP

Tools and Special Equipment:

Personnel Required: (2)

Shop Equipment, SC 4910-95-CL-A72

General Safety Instructions:

Tool Kit, SC 5180-90-CL-N26

Material/Parts:

WARNING

Front bumper weighs 260 lb (118 kg). Use

Nut, Lock (2)

suitable lifting device to remove or install front

bumper to prevent possible injury to personnel.

Nut, Lock (20)

REMOVAL

REMOVE TWO LOCK NUTS (1), TWO WASHERS (2), TWO SCREWS (3), TWO WASHERS (4), AND BRACKET

(5) FROM FRONT BUMPER (6). DISCARD LOCK NUTS.

WARNING

Front bumper weighs 260 lb (118 kg). Use suitable lifting device to remove or

install front bumper to prevent possible injury to personnel.

ATTACH SUITABLE LIFTING DEVICE TO FRONT BUMPER (6) USING LIFTING SHACKLES (7) AS ATTACHING

POINTS. ON M917A1 AND M917A1 W/MCS, USE LIFTING SHACKLES ON COMBINATION TOWING/LIFT/TIE-

DOWN BRACKETS (8).

NOTE

Note bolt size and location during removal to aid in installation.

M915A2 towing brackets are shown. M916A1 and M916A2 towing brackets are

installed pointing down. On M917A1 and M917A1 w/MCS, towing brackets are

configured to serve as combination towing/lift/tie-down brackets.

REMOVE 12 LOCK NUTS (9), 12 WASHERS (10), 12 BOLTS (11), 12 WASHERS (12), 2 TOWING BRACKETS

(8), AND FRONT BUMPER (6). DISCARD LOCK NUTS.

LOWER BUMPER (6) TO GROUND AND DISCONNECT LIFTING DEVICE.

REMOVE EIGHT LOCK NUTS (13), EIGHT WASHERS (14), EIGHT BOLTS (15), EIGHT WASHERS (16), AND

TWO LIFTING BRACKETS (17) FROM FRONT BUMPER (6). DISCARD LOCK NUTS.

CLEANING/INSPECTION

4-628 Change 3