 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
REAR HUB, DRUM, WHEEL BEARINGS, AND SEAL REPLACEMENT (CONT)
INSTALLATION
0.1
ON M917A1 AND M917A1 W/MCS, INSTALL CTIS TUBE ON AXLE SPINDLE AND AXLE FLANGE (PAGE 4-
604.29).
0.2
ON M917A1 AND M917A1 W/MCS, INSTALL CTIS SEALS (PAGE 4-604.1).
CAUTION
Bearings and bearing cups must be replaced as a set. Failure to do so could
result in premature damage to either bearings or bearing cups.
NOTE
Procedure is the same for both sides.
Procedure is the same for both rear axles except as noted.
1.
USING BRASS DRIFT PIN, CAREFULLY INSTALL TWO NEW BEARING CUPS (1) IN HUB (2).
2.
IF REMOVED, INSTALL EIGHT NEW STUDS (3) IN HUB (2).
3.
COAT INNER WHEEL BEARING (4) WITH AXLE OIL.
4.
INSTALL INNER WHEEL BEARING (4) IN HUB (2).
5.
INSTALL NEW OIL SEAL (5) IN HUB (2).
6.
INSTALL HUB (2) ON AXLE SPINDLE (6) AND FILL CAVITY WITH AXLE OIL.
4-596 Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals