INSTALLATION (Cont) -699580816

TM 9-2320-363-20-2

FRONT HUB, DRUM, WHEEL BEARINGS, AND SEAL REPLACEMENT (CONT)

NOTE

During installation of hub and drum assembly, it is critical that hub and drum

assembly be installed straight and evenly to allow proper adjustment of ABS

sensor.

INSTALL HUB AND DRUM ASSEMBLY (2) ON AXLE SPINDLE (8).

APPLY GAA TO INSIDE OF OUTER BEARING CUP (1).

10.

PACK OUTER BEARING (9) WITH GAA.

11.

INSTALL OUTER BEARING (9) ON AXLE SPINDLE (8).

12.

INSTALL LOCK NUT (10) ON AXLE SPINDLE (8) UNTIL LOCK NUT (10) CONTACTS OUTER BEARING (9).

CAUTION

During step 13, hub must be rotated in both directions. Failure to do so could

result in premature bearing failure.

13.

USING BEARING NUT WRENCH, TIGHTEN LOCK NUT (10).

14.

LOOSEN LOCK NUT (10) 1/4 TURN.

NOTE

During step 15, it may be necessary to tighten lock nut to aline recess in axle

spindle with lock nut opening.

15.

INSTALL LOCK (11) IN LOCK NUT (10) AND AXLE SPINDLE (8) RECE SS.

NOTE

To perform step 16, it may be necessary to rotate hub and drum assembly.

16.

INSTALL NEW LOCK WASHER (12) AND SCREW (13).

4-592 Change 2