 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
3.
INSTALL INSIDE WHEEL BEARING (5) AND NEW OIL SEAL (6) IN HUB (3).
4.
APPLY FILM OF LUBRICATING OIL ON AXLE SPINDLE (7).
CAUTION
To prevent damage to equipment, do not unseat oil seal or bearing when mounting
hub.
5.
MOUNT HUB (3) FULLY OVER AXLE SPINDLE (7).
6.
FILL CAVITY IN HUB (3) WITH LUBRICATING OIL.
7.
INSTALL OUTSIDE WHEEL BEARING (4) IN HUB (3).
NOTE
Install adjusting nut dimple facing out.
8.
WHILE TURNING HUB (3), THREAD ADJUSTING NUT (8) ON AXLE SPINDLE (7) UNTIL IT IS AGAINST
OUTSIDE WHEEL BEARING (4).
WHILE TURNING HUB (3) IN BOTH DIRECTIONS, TIGHTEN ADJUSTING NUT (8) TO 100 LB-FT (136 Nm).
9.
10.
LOOSEN ADJUSTING NUT (8) COMPLETELY TO ZERO TORQUE AND SPIN WHEEL A FEW TURNS.
TIGHTEN ADJUSTING NUT TO 50 LB-FT (68 Nm).
11.
BACK OFF ADJUSTING NUT (8) 1/6 TO 1/4 TURN.
12.
INSTALL LOCK RING (9) AND NEW LOCK WASHER (10) OVER AXLE SPINDLE (7).
THREAD JAM NUT (11) ONTO AXLE SPINDLE (7) AND TIGHTEN TO 100-150 LB-FT (136-203 Nm).
13.
14.
BEND TAB OF LOCK WASHER (10) OVER A FLAT OF JAM NUT (11).
15.
ALINE HUB CAP (12) AND NE W GASKET (13) OVER HUB (3) AND INSTALL SIX CAPSCREWS (14) AND SIX
NEW LOCK WASHERS (15). TIGHTEN CAPSCREWS TO 15 LB-FT (20 Nm).
16.
REMOVE HUB FILLER CAP (16) AND ADD LUBRICATING OIL TO LEVEL OF FILLER HOLE. WAIT 5 MINUTES;
ADD OIL, AS NEEDED.
17.
INS TALL HUB FILLER CAP (16).
18.
INSTALL BRAKE DRUM (17) OVER HUB (3).
19.
INSTALL PRESSURE RELIEF CAPSCREW, SPRING, AND PAWL ASSEMBLY (18) IN SLACK ADJUSTER (19).
TIGHTEN TO 15-20 LB-FT (20-27 Nm).
NOTE
Follow-on Maintenance:
Install front wheel (TM 9-2320-363-10).
Adjust slack adjuster (page 4-447).
Install front Anti-Lock Brake System (ABS) sensor (page 4-285).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals