 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9-2320-363-20-2
1.
APPLY THIN FILM OF ANTISEIZE COMPOUND ON SPLINES OF S-CAM (1).
2.
INSTALL WASHER (2) ON S-CAM (1).
INSTALL S-CAM (1) THRU TUBE OF MOUNTING BRACKET (3).
3.
4.
INSTALL WASHER (4), AS TAGGED DURING REMOVAL, ON SHAFT OF S-CAM (1).
5.
INSTALL SLACK ADJUSTER (5) OVER SPLINES OF S-CAM (1) WITH CAPSCREW (6) TOWARD
VEHICLE.
6.
INSTALL WASHERS (7), AS TAGGED DURING REMOVAL, AND RETAINING RING (8) TO SECURE
SLACK ADJUSTER (5) TO S-CAM (1).
NOTE
I f repeating installation because m e a s u r e m e n t i n s t e p 1 6 e x c e e d e d 0 . 0 6 i n .
( 1 . 5 mm), add one more washer t h a n noted in step 3 of Removal.
7.
REMOVE CAPSCREW (6), SPRING (9), AND PAWL (10).
8.
TURN ADJUSTING SCREW (11) TO ALINE SLACK ADJUSTER (5) WITH BRAKE CHAMBER CLEVIS
(12).
NOTE
Step 9 is for front of vehicle.
HOLD S-CAM (1) IN POSITION NOTED DURING REMOVAL AND TURN ADJUSTING SCREW (11)
9.
TO ALINE SLACK ADJUSTER (5) WITH BRAKE CHAMBER CLEVIS (12).
10.
INSTALL LARGE CLEVIS PIN (13) IN BRAKE CHAMBER CLEWS (12).
11.
PULL OUT ACTUATOR ROD (14) UNTIL HOLE IN TOP OF ACTUATOR ROD (14) IS ALlNED WITH
SMALL HOLE IN BRAKE CHAMBER CLEVIS (12).
12.
INSTALL SMALL CLEWS PIN (15) IN BRAKE CHAMBER CLEVIS (12).
13.
INSTALL PAWL (10), SPRING (9), AND CAPSCREW (6). TIGHTEN CAPSCREW TO 15-20 LB-FT
(20-27 N.m).
4-439
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals