 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
5.
REMOVE TWO TOP AND TWO BOTTOM
SCREWS (12) FROM FRONT AND REAR OF
SHIFT TOWER (13).
6
INSTALL REAR ACCESS PANEL (14) AND SIX
SCREWS (12).
7.
REPEAT STEP 6 TO INSTALL FRONT ACCESS
PANEL.
8.
AT TRANSFER CASE, CONNECT TRANSFER
CASE SHIFT CABLE (PAGE 4-376).
ADJUSTMENT
1.
PLACE TRANSFER CASE SELECTOR LEVER IN "LOW" POSITION.
2.
DISCONNECT CLEVIS (1) FROM TRANSFER CASE SHIFT LEVER (2) BY REMOVING COTTER PIN (3) AND
PIN (4).
3.
PUSH TRANSFER CASE SHIFT LEVER (2) TOWARD TRANSFER CASE (5) AS FAR AS IT WILL GO.
4.
LOOSEN NUT (6) AT CLEVIS (1).
5.
KEEPING CABLE FULLY EXTENDED (TOWARD TRANSFER CASE) BY HAND, ROTATE CLEVIS (1) UNTIL IT
IS ALIGNED WITH TRANSFER CASE SHIFT LEVER (2) AND PIN (4) CAN BE INSTALLED WITHOUT MOVING
CABLE (7) OR TRANSFER CASE SHIFT LEVER (2)
6.
TIGHTEN NUT (6) AT CLEVIS (1).
7.
CONNECT CLEVIS (1) TO TRANSFER CASE SHIFT LEVER (2) WITH PIN (4) AND COTTER PIN (3).
Change 3 4-384.15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals