BLACKOUT MARKER LIGHT AND WIRING HARNESS REPLACEMENT

TM 9-2320-363-20-2

BLACKOUT MARKER LIGHT AND WIRING HARNESS REPLACEMENT

This task covers:

a. Removal

b. Cleaning/Inspection

c. Installation

INITIAL SETUP

Applicable Configuration:

Materials/Parts:

All except M915A2 and M916A1

Nut, Lock (3)

Tools and Special Equipment:

Washer, Lock

Tool Kit, SC 5180-90-CL-N26

Tags, IdentificationAppendix C, Item 26

Equipment Description:

Reference

Condition Description

Page 2-29

Batteries Disconnected

NOTE

Both blackout marker lights and wiring harnesses are removed and installed

the same way. Right front blackout marker light and wiring harness is

illustrated.

Tag all connectors and wires prior to removal to aid in installation.

REMOVAL

DISCONNECT HARNESS (1) FROM BACK OF BLACKOUT MARKER LIGHT (2).

REMOVE THREE SCREWS (3), THREE WASHERS (4), THREE LOCK NUTS (5), CLAMP LOOP (6), AND

BLACKOUT MARKER LIGHT (2) WITH BRACKET (7) FROM FENDER. DISCARD LOCK NUTS.

REMOVE NUT (8), LOCK WASHER (9), GROUND WIRE (10), AND BLACKOUT MARKER LIGHT (2) FROM

BRACKET (7). DISCARD LOCK WASHER.

REMOVE GROMMET (11) AND FEED HARNESS (1) THROUGH FENDER.

DISCONNECT CONNECTORS (12).

CLEANING/INSPECTION

Clean and inspect all parts in accordance with Chapter 2.

4-213.2 Change 3