INSTALLATION -699580273

TM 9-2320-363-20-2

CLEANING/INSPECTION

Clean and inspect all parts in accordance with Chapter 2.

INSTALLATION

INSTALL TWO AIR VENTS (29).

POSITION PANEL (5) AT DASH BOARD.

INSTALL INDICATOR LIGHT (28) TO PANEL (5) WITH WASHER (27) AND NUT (26).

INSTALL SWITCH (25) TO PANEL (5). INSTALL PIGTAIL (24) TO SWITCH WITH TWO SCREWS (23).

CONNECT TWO CONNECTORS (22).

NOTE

There are two control valves and associated hardware on upper right dash panel,

tailgate release control valve (M917A1 and M917A1 w/MCS) (top) and all-wheel

drive control valve (bottom). One is illustrated.

INSTALL TEE (21), TWO ELBOWS (19), AND SENDING UNIT (20) TO CONTROL VALVE (18)

INSTALL CONTROL VALVE (18) AND GUARD (17) TO PANEL (5) WITH TWO SCREWS (16).

CONNECT TWO TUBES (14). CONNECT CONNECTOR (15) TO SENDING UNIT (20).

INSTALL THREE LABEL HOLDERS (12). INSTALL TWO SWITCHES (10) TO PANEL (5) WITH NUTS (13).

INSTALL THREE FIBER OPTIC LABELS (11).

10.

CONNECT TWO CONNECTORS (9) TO SWITCHES (10).

11.

AS REQUIRED, INSTALL THREE WASHERS (8), KNOBS (7), AND SCREWS (6) TO LIGHT SWITCH (2).

12.

INSTALL LIGHT SWITCH (2) TO PANEL (5) WITH FOUR SCREWS (4) AND NUTS (3).

13.

CONNECT CONNECTOR (1) TO LIGHT SWITCH (2)

NOTE

Follow-on Maintenance:

Install parking brake and trailer air supply valves (page 4-568).

Connect batteries (page 2-29).

Change 3 4-185.3