 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
11.
REMOVE ALTERNATOR PULLEY (22) FROM VISE AND REMOVE ALTERNATOR PULLEY (22) FROM
ALTERNATOR (4).
CLEANING/INSPECTION
Clean and inspect all parts in accordance with Chapter 2.
INSTALLATION
1.
INSTALL ALTERNATOR PULLEY (22) ON ALTERNATOR (4).
2.
HOLDING ALTERNATOR PULLEY (22) IN SOFT-JAWED VISE, INSTALL KEY (24) AND NEW LOCKNUT (23).
3.
IF REMOVED, INSTALL ADJUSTING ROD (12) AND SECURE WITH CAPSCREW (19), NEW LOCK WASHER
(20), AND SPACER (21).
4.
IF REMOVED, INSTALL ALTERNATOR BRACKET (16) AND SECURE WITH TWO BOLTS (17) AND TWO NUTS
(18).
5.
SUPPORT ALTERNATOR (4) AND INSTALL CAPSCREW (14), BEARING WASHER (15), AND HEX NUT (13).
6.
SLIDE LINK END (11) ONTO ADJUSTING ROD (12).
7.
INSTALL HEX NUT (10) ONTO ADJUSTING ROD (12).
8.
ALIGN HOLE IN LINK END (11) WITH TOP MOUNTING HOLE ON ALTERNATOR (4) AND INSTALL CAPSCREW
(8) AND BEARING WASHER (9).
9.
INSTALL ALTERNATOR DRIVE BELT (PAGE 4-155.0).
10.
ADJUST ALTERNATOR DRIVE BELT (PAGE 4-155.0)
11.
ON REAR OF ALTERNATOR (4), CONNECT SIX ELECTRICAL LEADS (7) AND SECURE WITH TWO NUTS (5)
AND TWO WASHERS (6).
12.
ON TOP OF ALTERNATOR (11), CONNECT FOUR ELECTRICAL LEADS (3) AND SECURE WITH TWO NUTS
(1) AND TWO WASHERS (2).
NOTE
Follow-on Maintenance:
Connect batteries (page 2-29).
Change 3 4-153.3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals