 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
FAN BELT REPLACEMENT AND ADJUSTMENT (CONT)
ADJUSTMENT
1.
USING TENSIOMETER (1), TIGHTEN ADJUSTING SCREW (2) UNTIL FAN BELT (3) TENSION IS 60-80 LBS
(266-355 N).
2.
TIGHTEN FOUR SCREWS (4) TO 75-83 LB-FT (100-112 N.m).
3.
OPERATE ENGINE FOR ABOUT 30 MINUTES (OR 15 MILES), THEN CHECK BELT TENSION. CHECK AGAIN
AFTER 8 HOURS (OR 250 MILES). ADJUST BELT TENSION AS NEEDED.
NOTE
Follow-on Maintenance:
Install fan impeller and shroud (page 4-120).
4-140 Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals