 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
7.
INSTALL TWO HEAT SHIELD CLAMPS (26), TWO SCREWS (27), AND TWO NUTS (28) ON MUFFLER (29).
8.
SLIDE HEAT SHIELD (30) ON MUFFLER (29) AND INSTALL EIGHT SCREWS (31).
WARNING
Install seal clamps only hand-tight until all exhaust pipes are installed and
tightened down. Failure to do so will cause exhaust leaks and can result in serious
personnel injury.
9.
INSTALL NEW SEAL CLAMP (32) ON MUFFLER (29).
NOTE
Washers are used for muffler alinement. Use only enough washers to keep muffler
straight.
10.
USING SUITABLE LIFTING DEVICE, SUPPORT MUFFLER (29) AND INSTALL MUFFLER (29), WASHERS (33),
TWO SADDLE CLAMPS (34), AND FOUR NUTS (35).
11.
INSTALL EXHAUST STACK (36), SADDLE CLAMP (37), AND TWO NUTS (38).
12.
INSTALL CAP (39) IN SAME POSITION AS REMOVED AND TIGHTEN NUT (40).
13.
TIGHTEN SEAL CLAMP (32) TO 33 LB-FT (45 N.m).
Change 3 4-93
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals