|
|
TM 9-2320-363-20-2
MUFFLER AND EXHAUST STACK REPLACEMENT (CONT)
REMOVAL
1.
REMOVE FOUR NUTS (1), TWO SADDLE CLAMPS (2), AND EXHAUST STACK (3).
NOTE
Note position of cap for installation. Orientation of M917A1 and M917A1 w/MCS
cap differs from other models.
2.
LOOSEN NUT (4) AND REMOVE CAP (5).
3.
USING SUITABLE LIFTING DEVICE, SUPPORT MUFFLER (6) AND LOOSEN SEAL CLAMP (7).
NOTE
Quantity of washers may vary. Washers are used for alinement.
4.
REMOVE TWO NUTS (8), SADDLE CLAMP (9), WASHERS (10), MUFFLER (6), AND SEAL CLAMP (7).
DISCARD SEAL CLAMP.
5.
REMOVE EIGHT SCREWS (11) AND SLIDE HEAT SHIELD (12) OFF MUFFLER (6).
6.
REMOVE TWO NUTS (13), TWO SCREWS (14), AND TWO HEAT SHIELD CLAMPS (15).
4-90 Change 3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |