ETHER STARTING AID REPLACEMENT -699580124

TM 9-2320-363-20-2

ETHER STARTING AID REPLACEMENT

a. Removal b. Cleaning/Inspection c. Installation

This task covers:

INITIAL SETUP

Equipment Condition:

Applicable Configuration:

M916A1

Reference

Condition Description

Page 2-29

Batteries Disconnected

Toolis and Special Equipment:

Ether Starting Aid Fuel

TOOl Kit, SC 5180-90-CL-N26

Cylinder Removed

Materials/Parts:

Washer, Lock (4)

Nut, Lock

Nut, Lock (2)

DISCONNECT TUBE (1) FROM CONNECTOR (2).

DISCONNECT CONNECTOR (3) FROM HARNESS (4).

DISCONNECT TUBE (1) FROM ATOMIZER (5).

DISCONNECT ATOMIZER (5) FROM BUSHING (6).

REMOVE BUSHING (6) FROM INTAKE MANIFOLD (7).

REMOVE TWO WING NUTS (8), TWO LOCK WASHERS (9), AND SADDLE (10). DISCARD LOCK

WASHERS.

REMOVE TWO NUTS (1 1), TWO LOCK WASHERS (12), TWO STUD AND NUT ASSEMBLIES (13),

AND CLAMP (14) FROM STARTING AID MOUNTING BRACKET (15). DISCARD LOCK WASHERS.

REMOVE LOCK NUT (16), WASHER (17), CLAMP (18), WIRE (19), AND SCREW (20) FROM

STARTING AID MOUNTING BRACKET (15). DISCARD LOCK NUT.

REMOVE CONNECTOR (2) FROM VALVE (21).

10.

REMOVE CAP (22) FROM VALVE (21 ).

11.

LOOSEN TWO SCREWS (23) AND REMOVE VALVE (21) FROM STARTING AID MOUNTING

BRACKET (15).

12.

IF TUBE (1) IS DAMAGED, REMOVE SCREW (24), CLAMP (25), AND TUBE (1).

13.

IF STARTING AID MOUNTING BRACKET (15) IS DAMAGED, REMOVE TWO LOCK NUTS (26), TWO

SCREWS (27), STARTING AID MOUNTING BRACKET (15), AND TWO SPACERS (28) FROM

FRAME RAIL (29).