Figure C-17. Turbocharger Holding Fixture (PN 2SK742)

TM 9-2320-360-34-2

(1)

Fabricate from 3/4 in. (19 mm) exterior grade plywood.

(2)

Drill 1-1/2 in. (38 mm) diameter hole in center of base.

(3)

Drill four 1/2 in. (13 mm) diameter holes in corners of base.

(4)

Draw a circle with a 1-5/8 in. (41 mm) radius.

(5)

Route four 1/2 x 3/4 in. (13 x 38 mm) slots in base into circle as shown.

(6)

Fabricate two 1-15/16 x 2-1/2 x 1-1/4 in. (49 x 63.5 x 32 mm) fingers from plywood.

(7)

Grind bottom of fingers 23/32 in. (18 mm) wide and 7/16 in. (11 mm) high. Contour front surface of fingers to fit

turbine wheel blades.

(8) All dimensions are in inches (millimeters).

Figure C-17. Turbocharger Holding Fixture (PN 2SK742)

Change 2 C-11