 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
28-6. POWER TAKEOFF REPAIR (CONT)
(23) Lightly coat mounting surface of PTO
housing (22) with grease.
WARNING
Adhesive-sealant may burn or give
off harmful vapors. It Is harmful to
skin and clothing. To avoid Injury or
death, keep away from open flame
and use In well-ventilated area. If
adhesive-sealant gets on skin or
clothing, wash Immediately with soap
and water.
(24) Coat thr eads of four screws (27) with
adhesive-sealant
(25) Install new gasket (28) and open-end
bearing cover (26) on PTO housing (22)
with four screws (27). Torque to 214-240
lb-in. (23-27.1 Nm).
(26) Install needle bearing (29), bearing spacer
(30), and needle bearing (29) in input gear
(31).
(27) Align flat spot on idler shaft (32) with
setscrew hole (33).
NOTE
Slot on idler gear should face out.
(28) Press Idler shaft (32) in PTO housing (22)
until 0.25 in. (6 mm) shows in opening on
PTO housing (22).
(29) Install thin thrust race (34), thrust bearing
(35), and thick thrust race (36) on idler
shaft (32).
NOTE
Leave space to install thrust races
and thrust bearing.
(30) Install input gear (31) on idler shaft (32).
Press idler shaft through input gear (31).
(31) Install thin thrust race (34), thrust bearing
(35), and thick thrust race (36) under input
gear (31).
(32) Install idler shaft (32) completely in PTO
housing (22).
(33) Coat threads of setscrew (37) with
adhesive-sealant and install in PTO
housing (22). Torque to 30 lb-in. (3.4
Nm).
28-70
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals