Assembly (Cont.) -726030536

TM 9-2320-360-34-2

28-3. DRIVE MOTOR REPAIR (CONT)

(10) install wear plate (9) on bearing housing (2).

(11) Coat seal (10) with petroleum jelly and install in

groove in wear plate (9).

(12) Insert drive (11) into bearing housing (2).

NOTE

Star and rollers must be in place

when installing geroler assembly.

(13) Install geroler assembly (12) on wear plate (9).

NOTE

The direction output shaft rotates is

determined by timing.

(14) Locate largest opening pocket

geroler

assembly (12). Mark its position.

(15) install valve drive (13) in geroler assembly (12).

(16) Coat seal (14) with petroleum jelly and install in

groove in valve plate (15).

(17) Align scribe marks and install valve plate (15) on

geroler assembly (12).

(18) Locate open slot in valve plate (15) that is in line

with largest open pocket in geroler assembly

(12).

(19) Align any side opening in valve (16) with open

slot in valve plate (15) that is over largest open

pocket in geroler assembly (12).

NOTE

Valve will fall into place and rest flat

on valve plate when properly seated.

(20) Engage valve (16) with valve drive (13) by

rotating it clockwise until spline teeth mesh (1/2

spline tooth).

28-36