Cleaning/Inspection -726030496

TM 9-2320-360-34-2

(6) Remove plug (9) from in put housing (4).

(7) Remove three plugs (10) from output

housing (5).

NOTE

Mark location of oil seal and plug

before removing to aid in installation.

(8) Remove plug (11), oil seal (12) and two

bearing cups (13) from input housing (4).

Discard oil seal.

(9) Remove plug (14), oil seal (15), and two

bearing cups (16) from output housing (5).

Discard oil seal.

(10) Remove two bearing cones (17) from

input shaft (6).

(11) Remove two bearing cones (18) and

shims (19) from output shaft (7).

(12) Position output shaft (7), gear (20) side

up, in suitable press.

CAUTION

Protect output shaft from striking

floor while pressing from gear.

Failure to comply may result in

damage to output shaft.

(13) Press output shaft (7) from gear (20).

(14) Remove key (21) from output shaft (7).

b. Cleaning/Inspection

WARNING

Dry cleaning solvent P-D-680 Is toxic and flammable. Wear protective goggles and

gloves and use solvent only in a well-ventilated area. Avoid contact with skin,

eyes, and clothes, and don't breathe vapors. Do not use near open flame or

excessive heat. The flash point Is 100-138 F (38-50 C). If you become dizzy while

using cleaning solvent, get fresh air immediately and get medical aid. If solvent

contacts eyes, wash eyes with water and get medical aid immediately.

(1) Clean metal parts in dry cleaning solvent.

27-53