Cleaning/Inspection -726030478

TM 9-2320-360-34-2

(26) Position bearing cap (5) in vise with outside of

bearing cap up.

(27)

Remove seal (30) and seal (31) from bearing

cap (5).

NOTE

High-pressure

seal

must

removed by pressing from outside

of bearing cap.

Some steering gears do not have

backup washer.

(28) Remove high-pressure seal (32) and backup

washer (32.1) from bearing cap (5). Discard

seal and washer.

(29) Remove bearing cap (5) from vise.

NOTE

Do not disassemble piston.

It must

be replaced as an assembly.

(30) Remove piston (33) from housing (1).

(31) Remove quad ring seal (34) from housing (1).

Discard quad ring seal.

NOTE

Do step

(32) if bearing

fails

inspection.

(32) Remove bearing (35) from housing (1).

b. Cleaning/Inspection

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and

gloves and use only in well-ventilated area. Avoid contact with skin, eyes, and

clothing, and don't breath vapors. DO NOT use near open flame or excessive heat.

the flash point is 100-38 F (38-59 C). If you become dizzy while using cleaning

solvent, get fresh air immediately and medical aid. If contact with eyes is made,

wash your eyes with water and get medical aid immediately.

(1)

Clean metal parts in dry cleaning solvent.

(2)

Inspect parts for damage, cracks, breaks, or deterioration.

(3)

Inspect parts with machined surfaces for deep scratches.

(4)

Remove small nicks or burrs with crocus cloth.

(5)

Coat internal parts with light coating of hydraulic fluid.

(6)

Replace unserviceable parts.

Change 1 27-35