Disassembly (Cont.) -726030468

TM 9-2320-360-34-2

(16) Remove plug (19) from cylinder head (8).

(17) Remove 12 screws (20) and lockwashers (21)

from cylinder head (8). Discard Iockwashers.

(18) Remove cylinder head (8) and preformed

packing (22) from housing (1).

Discard

preformed packing.

(19) Remove plug (23) and grease fitting (24) from

bearing cap (5).

(20) Remove 12 screws (25) and lockwashers (26)

from bearing cap (5). Discard lockwashers.

NOTE

Bearing cap is removed from housing

turning

input

shaft

counterclockwise out of piston. (21)

Remove

bearing

cap

(5)

and

preformed packing (27) from housing

(1). Discard preformed packing.

NOTE

Do steps (22) thru (29) if replacing

seals or actuating shaft.

(22) Position bearing cap (5) in soft-jawed vise with

actuating shaft (9) up.

(23)

Using 5/64 in. (2 mm) bit, drill retaining pin (28)

from bearing cap (5).

(24) Remove bearing retainer (29) from bearing cap

(5).

NOTE

Do not separate bearing from

actuating shaft. They are replaced as

an assembly.

(25) Remove actuating shaft (9) from bearing cap (5).

27-25