 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(15) Install spring washer (28), spring (29), and
spring washer (30) in cylinder block (31).
(16) Position two washers (32), screw (33),
and nut (34) in cylinder block (31).
NOTE
Nut should be tightened only enough
to install retaining ring.
(17) Tighten nut (34) to compress spring (29).
WARNING
Wear eye protection and use care
when installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
injury.
(18) Install retaining ring (35) in cylinder block
(31).
(19) Remove nut (34), screw (33), and two
washers (32) from cylinder block (31).
NOTE
Pin retainer must be installed 0.25 in.
(6045 mm) below surface.
(20) Install pin retainer (36) in cylinder block
(31).
NOTE
Pins must be installed in cylinder
block until they contact spring
washer.
(21) Install three pins (37) in cylinder block
(31).
(22) Position spherical washer (38) on top of
three pins (37).
(23) Install shoe plate (39) with nine pistons
(40) over spherical washer (38) and into
cylinder block (31).
(24) Install cylinder block (31) on shaft (4).
27-22.9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals