 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
27-2.1. AUXILIARY STEERING PUMP REPAIR (CONT)
NOTE
When properly assembled, yoke
should be stiff, but loose enough
to be moved by hand.
If yoke is too tight in pump
housing, add or remove shims
until correct preload is obtained.
(10) Install bearing cone (13), bearing cup (14),
bearing spacer (15), and new preformed
packing (16) in pump housing (2).
NOTE
Shims must be adjusted only if
new bearings are installed.
If shim thickness is greater than
0.02 in. (0.508 mm), another shim
must be added to opposite side of
yoke
to
reduce
total
shim
thickness to less than 0.02 in.
Shim thickness at either pintle
must not exceed 0.02 in. (0.508
mm).
(11) Install shim kit (17) and pintle cover (18)
on pump housing (2) with four screws
(19). Cross-tighten to 175-185 lb-in. (237-
251 Nm)
(12) Install bearing cone (20), bearing cup (21),
bearing spacer (22), and new preformed
packing (23) in pump housing (2).
(13) Install shim kit (24) and pintle cover (25)
on pump housing (2) with four screws
(26). Cross-tighten to 175-185 lb-in. (237-
251 Nm).
(14) Install two pins (27) in pump housing (2).
27-22.8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals