 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(11) Remove cylinder block (23) and three pins
(24) from shaft (25).
(12) Remove shoe plate (26), nine pistons
(27), and spherical washer (28) from
cylinder block (23).
(13) Remove pin retainer (29) from cylinder
block (23).
WARNING
Cylinder block spring must be held
by screw, washer, and nut before
removing retaining ring. Spring and
retaining ring are under high tension
and can act as projectiles when
released.
Failure to comply may
result in injury to personnel.
CAUTION
Do not clamp on flat surface of
cylinder block.
Failure to comply
may result in damage to machine
surface.
(14) Position cylinder bl ock (23) in soft-jawed
vice.
(15) Position two washers (30), screw (31),
and nut (32) through cylinder block (23).
NOTE
Spring must be compressed to allow
retaining ring to be removed.
(16) Tighten nut (32) and remove retaining ring
(33)
(17) Loosen nut (32) to relieve spring tension.
(18) Remove nut (32), two washers (30), and
screw (31) from cylinder block (23).
(19) Remove spring washer (34), spring (35),
and spring washer (36) from cylinder block
(23).
27-22.3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals