 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
26-2. AIR COMPRESSOR REPAIR (CONT)
(15) Coat connecting rod journal (22)
on
crankshaft (3) with lubricating oil.
(16) Position connecting rod (18) on crankshaft (3).
NOTE
Locating tab on bearing half must
insert in locating notch in
connecting rod cap. Align arrows
on connecting rod and cap.
Rotate crankshaft to gain access
to connecting rod screws.
(17) Install bearing half (23) and connecting
rod cap (24) on crankshaft (3).
(18) Install two screws (25) in connecting rod
cap (24) and connecting rod (18). Torque
to 105-135 lb-in. (11.9-15.3 Nm).
(19) Repeat steps (15) thru (18) for three
remaining piston and rod assemblies (13).
(20) Install new gasket (26) and plate (27) on
crankcase assembly (1) with four new
lockwashers (28) and screws (29).
Torque to 110-150 lb-in. (12.4-17 Nm).
(21) Install new gasket (30) and plate (31) on
crankcase assembly (1) with six new
lockwashers (32) and screws (33).
Torque to 110-150 lb-in. (12.4-17 Nm).
(22) Position new gasket (34) and cylinder
head (35) on cylinder block (14) with three
screws (36). Do not tighten screws.
(23) Install two new preformed packings (37)
on unloader pins (38).
(24) Install two springs (39) and unloader pins
(38) in cylinder head (35).
(25) Install new gasket (40) and unloader cover
(41) on cylinder head (35) with two
washers (42) and screws (43). Torque to
10 lb-in. (1.13 Nm).
(26) Position washer (44) and screw (45) on
cylinder head (35). Do not tighten screw.
(27) Install new preformed packing (46) on
cylinder head (47).
(28) Repeat steps (21) thru (26) for remaining
cylinder head (47).
26-10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals